Description
A full set of Arduino obstacle-avoiding robot assembly kit (DIY) for Arduino enthusiasts.
No soldering is required as it comes pre-soldered for two DC gear motors and one power on/off switch, unless there was an issue during transportation.
We provide a step-by-step installation guide, making it easy to build an obstacle-avoiding robot by following our guidelines precisely.
Specification
Chasis Dimension
~ 215mm x 156mm
Motor Working Voltage
DC3V ~ 6V
Packing List
Arduino Uno Compatible (CH340)
1pcs
Arduino Uno USB Cable
1pcs
L298N Motor Driver Boar
1pcs
Arduino Sensor Shield
1pcs
HC-SR04 Ultrasonic Module
1pcs
Standoff (metal)
4pcs (for Castor)
Standoff (plastic)
6pcs (for Uno board and L298 Motor Driver board)
Female to Female Jumper wires 10cm
10pcs
Female to Female Jumper wires 20cm
5pcs
Male to Male Jumper wires 20cm
3pcs
Wiring For Obstacle Avoiding Robot Car
Download
1 Arduino Obstacle Avoiding Robot Car Demo Code
2 Installation Manual
